Vue™ 1.1 User Manual
3
Rev. 4
Not all fixtures have a
voltage select switch.
Please be sure to connect
to the proper voltage.
1.
B
EFORE
Y
OU
B
EGIN
What is Included
Ø
1 x Vue™1.1
Ø
1 x Power Cord
Ø
1 x Warranty Card
Ø
1 x User Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all
parts are present, and have been received in good condition. Notify the shipper immediately and retain
packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs
of mishandling. Save the carton and all packing materials. In the event that a fixture must be returned to
the factory, it is important that the fixture be returned in the original factory box and packing.
AC Power
To determine the power requirements for a particular fixture, see the label
affixed to the back plate of the fixture or refer to the fixture’s specifications
chart. A fixture’s listed current rating is its average current draw under
normal conditions. All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel is used solely for a 0% to 100%
switch. Before applying power to a fixture, check that the source voltage
matches the fixture’s requirement. Check the fixture or device carefully to
make sure that if a voltage selection switch exists that it is set to the correct line voltage you will use.
Warning!
Verify that the voltage select switch on your unit matches the line voltage applied. Damage to your
fixture may result if the line voltage applied does not match the voltage indicated on the voltage
selector switch.
All fixtures must be connected to circuits with a suitable Earth Ground.
Safety Instructions
•
Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they
also receive this instruction booklet.
•
Always make sure that you are connecting to the proper voltage, and that the line voltage you are
connecting to is not higher than that stated on the decal or rear panel of the fixture.
•
This product is intended for indoor use only! To prevent risk of fire or shock, do not expose fixture to rain or
moisture.
•
Make sure there are no flammable materials close to the unit while operating.
•
The unit must be installed in a location with adequate ventilation, at least 20 in (50 cm) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
•
Always disconnect from power source before servicing or replacing lamp or fuse and be sure to replace
with same lamp source.
•
Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use its
carrying handles.
•
Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate fixture at temperatures higher than
this.
•
In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance center.
•
Never connect the device to a dimmer pack.
•
Make sure the power cord is never crimped or damaged.
•
Never disconnect the power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source while it is on.
Caution!
There are no user-serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact
CHAUVET® at: 954-577-4455.
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance of this product.
