Operating Modes
•
Two stand-alone modes; Sound-active mode will listen to sound and run through its diverse range
of built in programs and an Auto-run mode where the speed is pre-programmed.
•
Master/Slave mode will allow the command of up to as many units you want in a synchronized
light show to the sound.
•
DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be
controlled individually using any universal DMX-512 controller.
M a s t e r & S t a n d A l o n e ( P 6 )
In order to create the correct environment for Stand Alone
operation, several parameters have to be set in the control
panel. Please make the changes to the functions as listed in
the table below.
Note!
If the fixture is connected to a
controller, please disconnect it.
The display will read the previously
selected setting.
Only one fixture can be the Master
assigned fixture. However, 16 units
can be slaved to the master unit.
F
UNCTION
S
ET
T
O
N
OTES
P6
-y
Master mode (one Master only)
P4 -y
Sound
activated
A 001
Channel
address
S e t t i n g S l a ve F i x t u r e s
The Master/Slave mode will allow you to link multiple units in a daisy chain fashion. In this mode, the
first unit in the daisy chain, the master, will automatically command all other units following. The first
unit will operate in a Stand/Alone mode and all units following will synchronize to the first unit. Up to
16 fixtures can be daisy chained in Master/Slave mode.
M
ENU
S
ET
T
O
N
OTES
P6 -n Master
mode
P4 -n Sound
activated
A 001
Channel
address
S o u n d - a c t i ve ( P 4 ) o r A u t o - r u n ( P 5 )
In Master/Slave mode you can choose whether the fixture will run in a sound-active state where the
movement is triggered by sound or in auto-run where the speed is pre-programmed.
M
ENU
S
ET
T
O
N
OTES
P4 -y Sound
Activated
Or
P5 -y Auto-run
Q-Dream User Manual
10
2007-03-21/16:34
