O-
Beast™ User Manual
3
6/2/2009 2:39 PM
1.
B
EFORE
Y
OU
B
EGIN
What is included
1 x O-Beast
™
1 x Power Cord
1 x Warranty Card
1 x User Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have arrived in good condition. Notify the shipper immediately and retain
the packing material for inspection if any parts appear damaged from shipping or the carton shows
signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and
packing.
Symbols
This paragraph contains critical installation, configuration or operation information. Failure to comply
with this information may render the fixture partially or completely inoperative, cause damage to the
fixture or cause harm to the operator/user/technician.
This paragraph contains important installation or configuration information. Failure to comply with this
information may prevent the fixture from functioning correctly.
This paragraph reminds you of useful, although not critical, information.
AC Power
This fixture has an auto-switching power supply that can accommodate a wide range of input voltages
(100V - 240VAC, 50/60Hz). Before powering on the unit, make sure the line voltage to which you are
connecting it is within the range of accepted voltages.
Always connect the fixture to a switched circuit. Never connect the fixture to a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used only as a 0% to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its
average current draw under normal conditions.
Before
applying power to a fixture, check that the source voltage matches the fixture’s requirement.
Check the fixture or device carefully to make sure that if a voltage selection switch exists, it is set to
the correct line voltage you will use.
Always connect the fixture to a circuit with a suitable electrical ground.
