Configuration And Operation
Page 20 of 64
Net-X User Manual Rev. 4
Example Configuration 2: sACN and DMX Sources
This example demonstrates how to configure the Net-X to merge two sACN signals with LTP,
split two separate DMX signals, and output those signals and another sACN signal to several
separate DMX Out ports. The numbers used in this example are for demonstrative purposes,
and are only one of thousands of possible configurations.
First configure two sACN controllers to output signals with the same priority on Universe 6,
and a third sACN controller to output a signal on Universe 3. Then do the following:
1. Set the ethernet protocol for the Net-X to
sACN
. (See Ethernet Configuration.)
2. Set
IP Address #1
to
239.255.255.003
, and
IP Address #2
to
239.255.255.006
.
(See Configuring IP Addresses.)
3. Set the
Net Mode
to
LTP
, and the
DMX Mode
to
OFF
. (See Signal Merging.)
4. Set
Universe #1
and
#8
to
3
, and
Universe #3
and
#6
to
6
. (See sACN Universes.)
5. Set
DMX Output #1
,
#3
,
#6
, and
#8
to
sACN Input
,
DMX Output #2
and
#4
to
DMX #1 Input
, and
DMX Output #5
and
#7
to
DMX #2 Input
.
(See Configuring DMX Outputs.)
6. Plug in all input cables and output cables as shown in the Example 2 Diagram.
Example 2 Diagram
sACN Consoles
Switch or Router
(such as the
NET-SWITCH
from CHAUVET Professional)
DMX Controller 2
DMX Controller 1
sACN
Universe 3
sACN
Universe 6
sACN
Universe 6
Merged sACN Signal
(Universe 6)
DMX Signal 1
Separate sACN Signal
(Universe 3)
sACN Through Signal
(optional)
DMX Signal 2
DMX Signal 1
Merged sACN Signal
(Universe 6)
Separate sACN Signal
(Universe 3)
DMX Signal 2
DMX Cable
Neutrik®
etherCON® Cable
Содержание Net-X
Страница 1: ...User Manual Firmware V2 5 ...
