J-Six™ User Manual
7
Rev. 4
Hanging Clamp
Note!
Clamp is sold separately.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
Mounting
Orientation
This fixture may be mounted in any safe position, provided there is adequate room for
ventilation.
Rigging
It is important never to obstruct the fan or vents pathway.
Mount the fixture using, a suitable “C” or “O” type clamp. Adjust
the angle of the fixture by loosening both knobs and tilting the
fixture. After finding the desired position, retighten both knobs.
o
When selecting installation location, take into
consideration lamp replacement access and routine
maintenance.
o
Safety cables must always be used.
o
Never mount in places where the fixture will be exposed to
rain, high humidity, extreme temperature changes or
restricted ventilation.
Fuse Replacement
1.
With a flat head screwdriver wedge
the fuse holder out of its housing.
2.
Remove the damaged fuse from its
holder and replace with exact same
type fuse.
3.
Insert the fuse holder back in its
place and reconnect power.
3.
O
PERATING
I
NSTRUCTIONS
Standalone Mode (Sound-Active):
This mode allows a single unit to run to the beat of the music
1)
Plug the unit into power, using the provided power cable.
2)
The unit will react to the low frequencies of music via the internal microphone in Sound
Active mode.
3)
Use the audio sensitivity knob on the back of the unit to make the unit more or less
sensitive in Sound-Active mode. Turning the knob counterclockwise decreases the
sensitivity; turning the knob clockwise increases the sensitivity.
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
