Chauvet ColorDash Batten-Tri, Руководство пользователя, Страница: 11 / 26

Setup
COLORdash™ Batten-Tri User Manual Rev. 02a -7-
Continued from previous page
Master/Slave
Connectivity (Cont.)
The master and slave fixtures link to each other using the standard DMX serial
connection. If you are not familiar with the Master/Slave connectivity, you may download
the “DMX Primer” document from the CHAUVET® Web site.
DO NOT connect a DMX controller to the fixtures operating in Master/Slave mode.
Otherwise, the signals from the DMX controller may interfere with the signals from
the master unit.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
Mounting
Before mounting this fixture, read and follow the safety recommendations indicated in
the
Safety Notes section (page 2 of this manual).
Orientation
Always mount this fixture in any safe position while making sure that there is adequate
room around it for ventilation, configuration, and maintenance.
Make sure to mount this fixture away from any flammable material as indicated in the
Safety Notes section.
Rigging
CHAUVET® recommends following the general guidelines below when mounting the
COLORdash™ Batten-Tri.
•
When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments, and routine maintenance.
•
Never mount the fixture in places where rain, high humidity, extreme temperature
changes, or restricted ventilation may affect it.
•
If hanging this fixture, use a safety cable (not included) and make sure that the
location where you are mounting the fixture can support its weight. Please see the
Technical Specifications section of this manual for the weight requirement of this
fixture.
Procedure
The COLORdash™ Batten-Tri comes with a double bracket yoke to which you can
attach “C” or “O” clamps. This bracket also serves as a floor or wall mount support. You
must supply your own “C” or “O” clamps and make sure that they are capable of
supporting the weight of this fixture. You should use two mounting points per fixture.
Product Mounting
Diagram
C clamps
(Not provided)
Overhead Mounting
Floor Mounting