Chasswheel CW 4 FOUR X DL, Руководство по обслуживанию

Страница: 21 / 26

DX-2
www.chasswheel.com 21
8. CHANGING THE BALANCE ADJUSTING ACTUATOR
Removing of the actuator:
1. Remove the seat by opening 4 screws that holds the seat on the seat frame.
2. If the actuator is working, it is driven to middle position, when the gas spring tension is
lowest.
3. One battery terminal is detached.
4. Disconnect the actuator cable from the cable series, connector 2.
5. Remove the retaining cable tie from the back tube of the seat frame.
6. Open actuators fastening screws.
7. Release the actuator from the holder
Installation of the actuator:
1. Install rear part of the actuator in to the holder and stretch the screw and the nut.
2. Screw the actuators axle so that the axle’s hole and supporting frames retaining hole are
concentric.
3. The axel’s slot is pushed in to the mounting point and holes are aimed at concentric by using
for exemple a mandrel with help.
4. Tight the front end screw and the nut.
5. Attach the actuator’s cable with cable tie into the hole in the seat frame.
6. Connect the actuator’s cable in the cable series, connector 2.
7. Connect the battery and check the function.
8. Connect the battery and check the function
9. Check that the cables and pipes moves properly during motion.
10. Install the seat back.