Charnwood W625, Руководство оператора

Страница: 12 / 17

There is an adjustable, flip-over length stop on the
fence, to speed up repetitive work.
Use a set square to set the mitre fence extrusion at 90
degrees to the blade.
The mitre scale has two fixing screws which can be
loosened to make an adjustment to the scale if
necessary.
Next set the 90 degree return stop. The round silver
stop, has a fixing bolt drilled off centre. With the fence
still locked at the 90 degree position, loosen the fixing
bolt and rotate the stop until it touches the back of the
fence support. Tighten the fixing bolt.
Using The Table Saw
Start / Stop Switch
Blade Angle Scale
Blade Angle Locking Knob
Blade Height Scale
Blade Height Adjustment Handle
On/Off Switch
To turn the saw on, press the green button. Wait for the blade to reach its maximum speed
of rotation before commencing with the cut.
To turn the machine off again, press the red button.
The machine is fitted with an NVR (No Voltage Release) switch. This type of switch is
designed so that if the machine is disconnected from the mains whilst running and then
reconnected, the motor will not automatically restart.