Charnwood W625, Руководство оператора

Страница: 10 / 17

Optional Sliding Carriage
Note: If installed, remove the mitre fence guiderail which is bolted to the left hand side of the table.
Unpack the components and familiarise yourself with
them.
Identify the front and rear guide rail carriers. Fit one to
each end of the left hand side of the table, as shown.
Note that the front and rear are different.
To install the carrier, remove two of the bolts which
secure the leg to the table. Refit them with the carrier on
the outside of the table.
Next, bolt on the two support brackets, using three bolts,
with washers and nuts, as shown.
Use the larger M8 bolt here.
Slide the carriage table assembly onto the guide rail, as
shown. There are 6 bearings which sit in contact with the
guide rail.
They are a tight fit so you may need to push
to get it started.
The lower pair of bearings can be adjusted to get a tight
fit against the guide rail as necessary.
Fix the guide rail to the carriers with the four hex socket
head bolts provided. Note that the front end of the guide
rail, will project about 110mm in front of the main table.
Fit the remaining two cap head bolts through the ends of
the rail. These will act as travel limit stops for the
carriage and prevent the table from coming off the end
of the rail.