Charnwood Skye 5, Руководство по эксплуатации и установке

Страница: 12 / 20

12
®
INSTALLATION INSTRUCTIONS
load distributing plate.)
This may be stainless steel, cast iron, or thick wall steel pipe. Straight
lengths of Charnwood Pipe to match the stove are available if
required.
There are several ways of connecting the stove to the flue. These are
illustrated in Figs. 7 to 10.
CONNECTIONS TO FLUES
The stove must be connected to the flue using flue pipe of 125mm
(5") diameter - Skye 5.
If the top flue connection or optional vertical rear flue connector is
Fig. 9. Horizontal register plate with top flue connection
used then the chimney may be swept through the appliance.
Horizontal lengths of flue must be kept to a minimum and should not
be more in length than the flue diameter.
The stove comes with the blanking plate (fig. 11) fitted to the top flue
outlet. The seal for the
top outlet is a 155mm dia ring of rope seal.
The seal for the rear outlet is a length of adhesive backed fibre
webbing supplied with instructions. This is applied to the flue collar or
the Vertical Rear Flue adapter for rear outlet installations. For top
outlet installations, the blanking plate must be removed, have the
webbing fitted to its sealing face, and fitted to the rear flue outlet.
Ensure that the fold on the clamping plate is in line with the lugs on
the firebox as shown in Fig 11. Ensure that the clamping plate does
not prevent the throat plate from seating correctly. All flue
connections must be well sealed.
It is possible to pass a 16 inch diameter sweeps brush through the
appliance but in most back outlet installations it will be necessary to
have a soot door to enable the chimney to be swept. The optional
vertical rear flue connector does allow the chimney to be swept
through the stove.
The top outlet connection is made
directly to the cast top, the Skye store stand and low models are
supplied with a flue collar for rear outlet installations.
SOOT DOORS
PRE LIGHTING CHECK
Soot doors may either be in the actual brickwork
of the chimney or in the register plate. Various positions of soot doors
are shown in Figs. 7 to 10.
Ensure that the throat plate is fitted in the roof of the appliance. The
location and positioning of the throat plate is shown in Fig. 6.
Check that the front fence is fitted correctly and that the door closes
properly.
Fig. 10. Horizontal register plate with optional vertical rear flue connector
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Fig. 11. Flue Blanking Plate.
Blanking Plate
Glass Fibre Webbing
Seal Blanking Plate with
Glass Fibre Webbing
Blanking Plate
Back of Stove
Clamping Plate
M8 Nut
Clamping plate finishes
flush with the inside face
of the firebox top and
bottom.