10
PIC6-3
(1)
Component number:
on the left-side up corner (start from No.0). Press it you
can select the component number.
(2)
Comp. ID:
unique number
, it won’t have 2 same comp. ID in one work file.
M Stack:
stack 1-30 is for feeder, stack 61-80 is for user-defined IC, stack
81-100 is for IC tray.
(3)
Speed:
0
is for machine’s general max speed.
(for mounting IC, you can lower
down the speed a little such as 60-80, it will be more accuracy.
Note: machine
speed better not under 50
)
(4)
Height:
it is used for component height setting. The value is small for height
means the nozzle is more go down.
(Note: machine general height is 0.5mm
,
the general PCB thickness is 1.6mm, you can adjust the height according
to the thickness of your PCB
)
(5)
Angle:
for rotate angle of component.
(6)
Designator:
component identification information, such as R1, R2, C1, U1 etc.
(7)
Comments:
component information, such as 0402, 0805 etc.
(8)
M Head:
nozzle for this component
(9)
Coordinate X:
usually work file generated from software no need to change the
setting.
(10)
Coordinate Y:
usually work file generated from software no need to change the
setting
.