LIGHTING INSTRUCTION
1. Become familiar with safety guidelines in
front of the manual. DO NOT SMOKE
WHILE LIGHTING THE GRILL OR
CHECKING GAS SUPPLY
CONNECTIONS.
2. Check that each burner is tightened into its
properly location in front of each valve
orifice.
3. Make sure all gas connections are securely
tightened. TEST FOR LEAKS WITH A
SOAP SOLUTION, NEVER WITH A FLAME
(Gas leak check instructions are on page 6).
4. Always open lid before lighting.
5. Set control knobs to “OFF” and open the gas
supply cylinder valve (on natural gas units
make sure gas supply is open to the grill).
a. Open
Lid.
b. Push and turn any Control Knob
slowly to high.
c. Push and turn control know slowly
to HI position. The pilot will light
burner immediately. Release the
knob after the burner is lit.
d. Repeat igniter sequence for each
burner.
e. If the igniter has no spark, you may
light the burner with a match.
6. Adjust control knobs to desired cooking
temperature.
NOTE:
To light gas grill with a match, follow steps 1
through 6 above. Then, insert a lit extended
match or igniter through the cooking grids to the
burner. Press in the control knob and rotate left
to “HI” setting to releases gas. Burner should
light immediately.
CAUTION:
Do not move grill trolley while in operation.
If the grill fails to operate properly:
1. Turn off gas at source, turn control knob to
“OFF” and wait five minutes before trying
again.
2. Check gas supply connections.
3. Repeat lighting procedure and if grill still fails
to operate properly. TURN “OFF” GAS AT
ONCE, TURN CONTROL KNOBS TO
“OFF”, wait for grill to cool and check the
following:
a. Obstruction in gas line from grill.
CORRECTION: Remove fuel line
from grill. DO NOT SMOKE. Open
gas supply for one second to blow
any obstruction from fuel line. Turn
off gas supply at source and
reconnect fuel line to grill.
b. Misalignment of igniter on burner.
If re-ignition is necessary while the gas grill is
still hot, you must wait for a minimum of five
minutes before commencing to re-ignite (this
allows accumulated gas fumes to clear).
If all check/corrections have been made and gas
grill still fails to operate properly, consult your
grill dealer or gas appliance service person.
FLASH BACK:
When fire occurs in and around the burner tubes
immediately turn off the gas at its source and
turn the control knob(s) to “OFF”. Wait until the
grill has cooled, then clean burner tubes and
burner ports.
K15Y06N-1