Charlton & Jenrick Polaris 1000, Инструкция по установке и эксплуатации

Страница: 27 / 34

24
Rese ng the Thermal Cut Out
6b.39 The appliance is fi ed with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance overheats, e.g.
when covered. If the heater stops opera ng while the flame effect con nues working
normally, this indicates that the E.S. Control is in opera on. The E.S. Control can only be
re-set a er the appliance has cooled down, and the appliance has been reset. Re-
se ng of the E.S. Control proceeds is as follows:
6b.40 Switch off the appliance (Manual On/Off switch) and leave it off for approxi-
mately 10-15 minutes.
6b.41 Remove any obstruc on to the fan heater outlet or fan blades etc. Make sure
that the power supply is disconnected with the plug socket outlet while doing this.
6b.42 Switch on the appliance and the E.S. Control will be re-set.
6b.43 Ensure that the appliance is func oning correctly. If the E.S. Control operates
again, the appliance should be checked by a competent electrician.
Warning: Before any maintenance or cleaning of the exterior of the fireplace, the unit
should be disconnected from the power supply un l it is cool off.
Remote Handset Ba ery Replacement
7.1 When the ba eries are at full power, the ba ery symbol will show
7.2 When the ba eries are half full, the ba ery symbol will show
7.3 When the ba eries are out of power and need replacing immediately, the ba ery
symbol will show
7.4 Ba ery replacement is recommended a er 1 year. The ba eries are 1.5V alkaline
AAA, ba eries.
7.5 Dispose of old ba eries at an appropriate recycling facility.
Cleaning the Fireplace
Cleaning or polishing products are not recommended. Fingerprints or other marks on
the front glass panel can be removed by a piece of so , damp, lint-free cloth with a
good quality household glass cleaner. The front glass panel should always be completely
dried with a clean, lint-free cloth or paper towel.
Cau on: Abrasive cleaners should not be used on the glass panel. Liquids should not be
sprayed directly onto any surface of the unit.
7. MAINTENANCE