Charlton & Jenrick PARAGON P9, Руководство пользователя

Страница: 22 / 32

22 LT6974 (ISS 4)
CHECKING GAS SOUNDNESS AND RUNNING PRESSURE.
*Batteries must be connected before proceeding with any soundness testing*

Turn on the gas supply to the appliance and check for soundness in accordance with current codes of practice.

Turn off the gas supply at the external Isolation valve.

Remove the pressure test point screw from the inlet elbow and connect the pressure gauge.

Turn on the gas to the appliance at the Isolation valve.

Light the appliance as described in section 2.

Check the inlet pressure is /- 1 for natural gas or /- 1 for L.P.G.

Turn off gas supply, at the isolation valve. Disconnect the pressure gauge and replace the pressure test point
screw.

Turn on the supply to the appliance and check the pressure test point for soundness with detection fluid.

Refit the gas connection cover.

Fit the air tray within the location with the burner shelf.
LAY FUEL BED
Important: -
Refer to the Health & Safety Notice located on page 5 of this booklet before laying or replacing any refractory
material.
In the event of replacing fuel bed components please use only the specified number of components as illustrated.
Only use fuel bed component provided for this appliance. In the interest of safety and efficiency of your appliance
when replacing the fuel bed it is essential that the existing fuel bed be removed and the new components are
replaced correctly as a complete set.
Lay fuel bed as described under Users Section.
Warning:
It is important that the fuel bed components are positioned as shown in these instructions.
If the fuel bed components are not positioned correctly this may result in damage to the glass.