Charlton & Jenrick PANACHE 8040, Инструкция для пользователя, установка и обслуживание

Страница: 27 / 54

P a g e | 26
Issue No - 4(11/08/21)
PANACHE 8040 INSTALLATION INSTRUCTIONS
Checking the flue fire opening and fire opening.
Check that the chimney conforms to the required specification as previously stated. Examine
the condition and carry out any remedial work including removing any debris from the base.
If the flue has been used for solid fuel it should be swept prior to installation.
Prior to installing the appliance a smoke test (using a bomb) should be carried out to check that
satisfactory smoke clearance has been established. If all the smoke is not drawn into the flue,
pre-heat the flue with a blowtorch or similar and retest. If there is any uncertainty examine for
the cause and if necessary seek expert advice.
When installing the appliance against a dry lined plasterboard wall ensure that the void
between the plaster board and wall is sealed with a non-combustible material.
No combustible material should be fitted inside the fireplace opening.
Making the gas connection.
Remove the 3 screws to remove the gas access cover.
Fit isolation elbow to the inlet pipe as shown below. The grommet will need to be cut and
engaged within the firebox to form an air tight seal around the inlet gas supply pipe. Then refit
the gas access cover.