7
5.3 If installing in an existing fireplace and chimney always block the chimney
with fibreglass insulation or similar to prevent it sucking air away through the
appliance. Failure to do this may cause poor performance and loss of heat or
make the appliance cut out.
5.4 THE APPLIANCE IS FITTED WITH AN INLET PLUG AND SOCKET NDERNEATH
THE RIGHT SIDE OF THE CASING. ALWAYS MAKE SURE THAT IT IS FULLY
PUSHED IN AND SECURE BEFORE OPERATING THE FIRE. DAMAGE COULD
OCCUR IF IT IS NOT FITTED PROPERLY.
5.5 The electrical cable may be re-routed out of the rear or left side grommet
holes of the fire base but the grommet MUST be correctly located in the
exit slot to be used.
5.6 The product is fitted with a non-rewireable plug with a 13Amp fuse. Only
competent persons should attempt replacement.
The wires in the mains cable of this appliance are coloured in accordance with
the following code:
Blue = Neutral. Brown = Live. Green/yellow = earth.
Installation
Installation into a fireplace 16” opening/insert:
Note for this installation way, the secured spacer doesn’t need to be
removed from the engine.
