Instruction Manual - English
4E
CAUTION:
When connecting to a public water source, consult your local code. A backflow valve may
be required. (Chapin backflow valves sold separately Models: 6-9089 or 6-9088).
Do not operate with water sources above 116 PSI without installing a water preassure
regulator in-line before your water timer. Excessive pressure may cause damage to your
Water timer.
4.
Screen will flash between clock
time and minutes remaining before
program resumes.
5.
To remove manual watering, turn dial
6
to OFF or simply press again the
manual on/off button.
6.
To resume set program, turn the dial
6
back RUN.
CARING FOR YOUR TIMER
This timer is only designed for outdoor
use to control sprinklers or irrigation
systems for watering, and
CAN NOT
be
used for industrial purposes which in
contact with food, chemicals
and pesticides.
Operating water pressure is from 7 psi
to 116 psi.
DO NOT
connect direct to
water tank which has lower pressure
than 7 psi.
Use with clean and freshwater only with
temperature above 34˚ F and below
140˚ F.
Protect timer during winter season or
freezing conditions. Remove from tap
and drain water inside, remove battery
and keep indoors.
Your timer is water resistant, NOT water
proof. The timer must be installed above
ground and vertically to the tap.
DO NOT
submerge it in water.
to avoid damage to timer,
DO NOT
pull
the hose while attached to the timer.
If timer doesnot work, refer to
instructions to confirm connections and
intended use is appropriate. If timer
continues to perform not as intended,
contact the Chapin Customer Service/
Technical Support before returning to
the store.
