Champion 40903, Руководство владельца/оператора, Страница: 8 / 28

MAKE SURE WARNINGS ON FRONT TUBE
SUPPORTS ARE UPRIGHT.
Tighten all four nuts on Tube Supports securely.
Slide three pieces of Tubing (L) over ends of Front
Tube Supports (K) and Rear Tube Supports (N-15).
This ring indicates the approximate path of the
Throwing Arm (A).
STEP 1.
TRAP BODY TO POST MOUNT (FIG 5-6)
Mount the Pivot Mount (F) to the Post Mount (M)
assembly using the 12MM Hex Nut (N-2). Orientate
the Pivot Mount (F) so that the serrated face of the
pivot mount faces to the right as shown. Tighten
hex nut securely. After mounting the Pivot Mount,
attach the trap to the pivot mount using the 12MM x
30MM Lg. Hex Bolt (N-1). Pivot the trap slightly above
horizontal and tighten the hex bolt securely. This
setup will provide a good starting point for target
launch direction. Attach Trap Body Handle (O) to Trap
Body using bolt and washer on Trap Body Handle.
Front of Trap Body Handle fits under top of trap body
into slot and is then bolted to Trap Body.
Attach Trigger (Q) to tab on Trap Body (B) using 2
Bolts (N-20).
STEP 2.
TUBE SUPPORT ASSEMBLY (FIG-5)
Insert two 6MM X 90MM Lg. Hex Head Bolts (N-12)
through holes in the short Rear Tube Support (N-15),
through holes in sides at rear of Trap Body (A) and
through second Rear Tube Support (N-15). Attach
6MM Flange Nuts (N-13).
7
TRAP ASSEMBLY INSTRUCTIONS – POST MOUNT
CHAMPION
TRAPS & TARGETS
SKYBIRD
WARNING
AT ALL TIM
ES! SE
IOU S INJ UR
Y M AY
RES ULT . STA Y C LEA
R O F T HR
OW ING
ARM
Trap Body (B)
Trap Body Handle (O)
Tubes
Connect
Front Tube Support (K)
6MM X 90MM
Hex Bolts
(N-12)
6MM X 90MM
Hex Bolts
(N-12)
Arm Path Indicator Tubing (L)
Tubes
Connect
Front Tube Support (K)
6MM
Flange Nuts
(N-13)
Tubes
Connect
Rear Tube
Support (N-15)
6MM
Flange Nuts
(N-13)
Trigger (Q) &
6MM x 12MM Lg. Bolts (N-20)
Pivot Mount (F)
12MM x
30MM Hex
Bolt (N-1)
FIGURE 5
FIGURE 6
12MM Hex Nut
(N-2)
Tubes
Connect
Post Mount (M)
Rear Tube
Support (N-15)
6mm x 24mm
Hex Bolt &
M6 x 18mm
Washer
(N-21 & N-22)