Champion 40240, Инструкция пользователя, Страница: 5 / 16

4
ASSEMBLY INSTRUCTIONS
(CONTINUED)
STEP 5: (FIG. 8) Attach Throwing Arm (C) to Arm Support (D) using 3 Carriage Bolts (L-11) and 3 Flange Nuts (L-10).
Bolts should attach from underside, and Flange Nuts from top onto Throwing Arm. Tighten securely with Wrench.
STEP 6: (FIG. 9) Attach Target Clip (L-9) to Throwing Arm (C) by pressing it into the two slots making sure it “snaps” into
place. Be sure “finger” of Target Clip points in direction shown.
STEP 7: (FIG. 10) Attach Small Spring (L-1) to Arm
Support (D). First, hook one end of Spring into Groove,
and then hook the other end through hole in Pawl.
IMPORTANT: MAKE SURE END OF SPRING IS
HOOKED COMPLETELY THROUGH HOLE IN PAWL.
STEP 8: (FIG. 11) Apply Lubricant and then insert
Shaft of Arm Support (D) into Trap, as shown. Make
sure there is no gap between the Arm Support and the
Gear. If there is a gap, rotate the Arm Support until it
drops in place. Press the E-Clip (L-5) into Shaft Groove.
This will take a reasonable amount of force, so use Pliers to
press the E-Clip into place.
STEP 9: (FIG. 12) Swing Arm clockwise to the
12 o’clock position. Do not swing arm past the 12
o’clock position. Throwing Arm (C) should be in line
with Trap Body.
STEP 10: (FIG. 13) Drop Hex Bolt (L-6) inside Main
Spring (E). Connect loop of Main Spring to Arm Support (D)
and place bolt through hole in Support Bracket (I). Attach
Nylon Washer (L-4),
Flat Washer (L-3), and Hex
Nut (L-2). Tighten Nut
until Spring is taut. Gap
between end of Mainspring
and Bracket should not be
more than 1 inch. Attach
Wrench (J) and hold in
place with Wing Nut (L-8).
FIG. 9
L-9
FIG. 8
L-10
D
C
L-11
FINGER POINTS TOWARDS
TIP OF THROWING ARM
FIG. 10
HOOK SPRING COMPLETELY
THROUGH PAWL HOLE
L-1
L-1
D
FIG. 11
D
A
FIG. 13
D
E
J
L-6
L-4
L-3
L-2
L-8
GROOVE
PAWL
APPLY
LUBRICANT
TO SHAFT AND
TOP OF GEAR
GEAR
E-CLIP
(L-5)
I
HOOK SPRING COMPLETELY
THROUGH PAWL HOLE
FIG. 12
C