18
100883 - 27 TON LOg SPLiTTER
ASSEMbLY
high Pressure hydraulic hose
2. Place the provided o-ring (D) into the pump outlet fitting
(E) as shown. Make sure the o-ring is properly seated in
the inner groove of the fitting. Thread the loose end of the
high pressure hydraulic hose (F) onto the pump outlet (E).
Securely tighten the hose fitting with a 27mm wrench. Torque
to 44 lbf. ft – 52 lbf. ft. (60-71 Nm).
f
E
D
Low Pressure hydraulic hose
3. Thread the loose end of the low pressure hydraulic hose (G)
onto the tapered hydraulic fitting on the hydraulic fluid tank
(H). This hose fitting will only fit on this fitting to ensure
correct connection. Securely tighten the fitting with a 27mm
wrench (torque to 52 lbf.-ft. – 66 lbf.-ft. (71-90 Nm). Make
sure the fitting, when fully tightened, is angled upward as
shown.
g
H
8) install the Log Catchers
Large Log Catcher (Engine Side)
1. With the log catcher angled upward, align the four holes
on the log catcher with the 4 threaded holes on the splitter
beam.
2. Place M10 flat washers (25) and M10 lock washers (75) onto
the four M10 × 20 bolts (76) and thread them through the
holes on the log catcher and into the holes on the splitter
beam and tighten securely.
76
25
75
Small Log Catcher (hydraulic hose Side)
3. With the log catcher angled downward and under the lip of
the splitter beam, align the two holes on the log catcher with
the two holes on the beam lip.
4. Place the two M10 × 30 bolts (A) through the holes on the
beam and through the holes on the log catcher. Place a M10
flat washer (B) and a M10 lock washer (C) onto the bolt (A)
from the bottom side and thread the M10 nuts (D) onto the
bolts and tighten securely.
CORRECT aSSEmBLY
ORIENTaTION
A
C
b
D
INCORRECT aSSEmBLY
ORIENTaTION
A
C
b
D
