100544 - 7000W DUAL FUEL GENERATOR
OPERATION
24
Manual
1. Turn off and unplug all electrical loads. Never start or stop
the generator with electrical devices plugged in or turned
on (not required for wireless stopping.)
2. Let the generator run at no-load for several minutes to
stabilize internal temperatures of the engine and generator.
3. Turn the fuel select dial to the “OFF” position. Close the
propane (LPG) cylinder valve if operating by LPG.
Important:
Always ensure that the fuel select dial and the
start/stop button are in the “OFF” position when the generator
is not in use.
"
NOTICE
If the engine will not be used for a period of two (2) weeks or
longer, please see the
Storage
section for proper engine and
fuel storage.
Operation at High Altitude
The density of air at high altitude is lower than at sea level.
Engine power is reduced as the air mass and air-fuel ratio
decrease. Engine power and generator output will be reduced
approximately 3
½
% for every 1000 ft. of elevation above
sea level. This is a natural trend and cannot be changed by
adjusting the engine. At high altitudes increased exhaust
emissions can also result due to the increased enrichment of
the air fuel ratio. Other high altitude issues can include hard
starting, increased fuel consumption and spark plug fouling.
To alleviate high altitude issues other than the natural power
loss, CPE can provide a high altitude carburetor main jet.
The alternative main jet and installation instructions can be
obtained by contacting our Technical Support Team. Installation
instructions are also available in the Technical Bulletin area of
the CPE website.
"
NOTICE
No change is required if only using LPG.
The part number and recommended minimum altitude for the
application of the high altitude carburetor main jet is listed in
the table below.
In order to select the correct high altitude main jet it is
necessary to identify the carburetor model. For this purpose,
a code is stamped on the side of the carburetor. Select the
correct high altitude jet part number corresponding to the
carburetor code found on your particular carburetor.
Carb. Code High Alt. Jet Part Number
Min. Altitude
P28-10-Z
47.131017.21.01.Z
5500 ft.
(7000 m)
P28-10-H
47.131017.21.01.H
P28-10-Y
47.131017.21.01.Y
!
WARNING
Operation using the alternative main jet at elevations lower
than the recommended minimum altitude can damage the
engine. For operation at lower elevations, the originally
supplied standard main jet must be used. Operating the
engine with the wrong engine configuration at a given
altitude may increase its emissions and decrease fuel
efficiency and performance.
iLINK™ Wireless App
This generator is equipped with Bluetooth
®
wireless technology
that can be used to enable the generator through the Champion
iLINK™ wireless app. Download the Champion iLINK™ app to
your Android or iOS device and follow the instructions to set up
the generator.
The iLINK™ app allows the user to start, stop, and monitor the
generator through a smart device but is not required for normal
operation.
Google Play and the Google Play logo are trademarks of Google Inc.
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S.
and other countries. App Store is a service mark of Apple Inc., registered in the
U.S. and other countries.
Downloading Champion iLINK App
1. Download the Champion iLINK™ app from either Google
Play or App Store.
2. When you launch the app the first time, you will be brought
through a tour focusing on connecting, your dashboard,
notifications, and how to reach support for any questions.
3. For any subsequent steps, make sure your Bluetooth signal
is switched on in your smart device.
