Champion Pump CPSE10 Series Скачать руководство пользователя страница 11

Start-Up Report / Warranty Registration  

 

Please fill out the following questions as completely and accurate as possible.  Please mail 
to Champion Pump Company,  Inc. – P. O. Box 528 – Ashland,  OH 44805.  

REPORTS THAT ARE NOT RETURNED CAN DELAY OR VOID WARRANTY.  

Pump Owner’s 
Name:__________________________________________________________________ 
Address:________________________________________________________________ 
Location of installation:____________________________________________________ 
Phone:__________________________________________________________________ 
Purchased from:__________________________________________________________  

Pump Model_______________Serial #__________________Date Code:_____________  

Date Installed:____________________________________________________________  

Does impeller turn freely by hand? YES____________NO___________________  

Condition of cord jacket? Good________Fair________________Poor_____________  

Was equipment stored?___________How long?_________________________________ 
Liquid being pumped______________________________________________________ 
Debris in bottom of station?________Was debris removed in your presence?__________  

Discharge pipe size?___________ Length of pipe?_________Static lift?_____________  

Does station appear to operate at the proper rate?_______Pump down time?___________  

Voltage At Wiring Terminal  L1-L2__________L2-L3__________L1-L3__________ 
Run Amps  L1_______________L2_______________L3_______________ 
3 Phase Models – Check Proper Rotation?   Yes / NO 
 
Difficulties during start up: 
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________ 
I certify this report to be accurate (start up person)____________________________________ 
Employed by___________________________________ Date: _________________________  

Page 11 

Содержание CPSE10 Series












Отзывы: