11
REV 71321-20130513
ENGLISH
71321
ASSEMbly
1 . Place the pressure washer on a flat, level surface .
2 . Remove oil fill cap/dipstick to add oil .
3 . Add up to 1 .16 qt . (1 .1 L) of oil and replace oil fill
cap/dipstick . DO NOT OVERFILL .
4 . Check engine oil level daily and add as needed .
The engine is equipped with a low oil shut-off and
will stop when the oil level in the crankcase falls
below the threshold level .
CAUTION
Add Engine Oil
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil . Damage to the pressure
washer as a result of failure to follow these
instructions will void your warranty .
CAUTION
Check oil often during the break-in period . Refer to the
Maintenance section for recommended service intervals .
NOTE
The pressure washer engine shaft has a sealed,
pre-lubricated ball bearing that requires no
additional lubrication for the life of the bearing .
NOTE
The recommended oil type is 10W-30 automotive oil .
NOTE
Add Engine Oil Cont’d.
