201066 - 6500W OPEN FRAME INvERTER
CONTROLS AND FEATURES
13
Control Panel
1.
Ignition Switch
– Used to START or STOP the generator.
2.
Choke
– Used to start a cold engine.
3.
Intelligauge with Power Meter
– Four mode digital meter
for displaying run time, total time, voltage, hertz and power
output.
4.
AC Overload Reset Button
– Used to re-energize
receptacles after overload fault.
5.
Low Oil Warning Indicator Light
– When ON, engine will
shut down and not run. Check oil level.
6.
CO Shield
®
LED
– The CO Shield
®
technology monitors
for accumulation of poisonous carbon monoxide (CO) gas
produced by engine exhaust when the generator is running. If
CO Shield
®
detects elevated levels of CO gas, it automatically
shuts off the engine.
* *See CO Shield section for more information
7.
Economy Mode Button
– Enables/disables automatic idle
control.
8.
Circuit Breakers (Push Reset)
– Protects the generator
against electrical overloads.
RECEPTACLES
A
t
120V AC, 30A RV (NEMA TT-30R)
May be used to supply electrical power for
operation of 120 Volt AC, 30 Amp, single phase,
60 Hz electrical loads.
B
Y
120/240V AC, 30A Locking (NEMA L14-30R)
May be used to supply electrical power for
operation of 120/240 Volt AC, 30 Amp, single
phase, 60 Hz electrical loads.
C
C
(4×) 120V AC, 20A GFCI (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
D
z
12V DC, 8A (Regulated Automotive)
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
WARNING
Do not operate a device while it is plugged into the 12V DC
outlet. When charging a device, do not place on the exhaust
side of the generator. Extreme heat caused by exhaust
can damage the device and cause a potential fire hazard.
Prolonged exposure to engine exhaust can cause serious injury
or death.
1
2
3
6
7
4
5
8
8
D
A
b
C
