100680 - 27 iN. 2-STAgE SNOwbLOwER
MAiNTENANCE
25
Figure 22
4. With the engine in a level position, fill to the upper limit mark
on the dipstick with the recommended oil (0W-30) (Fig. 23).
5. Reinstall the oil cap/dipstick securely. Capacity of engine oil:
37.2 fl. oz. (1.1 L).
MAX
MIN
Figure 23
wARNiNg
–
Running the engine with a low oil level can cause engine
damage.
–
With engine off but still warm, disconnect the spark plug
wire and keep it away from the spark plug.
wARNiNg
Used oil is a hazardous waste product and must be disposed
of properly. Do not discard with household waste. Check
with your local regulations, service center, or dealer for safe
disposal/recycling facilities.
Cleaning and Adjusting the Spark Plug(s)
1. Remove the spark plug cable from the spark plug.
2. Use a spark plug socket (not included) to remove the plug.
3. Inspect the electrode on the plug. It must be clean and not
worn to produce the spark required for ignition.
4. Make certain the spark plug gap is 0.7 - 0.8 mm
(0.028 - 0.031 in.).
SPARK PLUG GAP
5. Refer to the spark plug section on the
Specifications
page
when replacing the plug.
6. Carefully thread the plug into the engine.
7. Use a spark plug socket (not included) to firmly install the
plug.
8. Attach the spark plug wire to the plug.
Replacing Shear Pins
The auger housing is shown as Fig. 24A. The augers are secured
to the auger drive with shear pins (A) and clips (B) (Fig. 24B). If the
auger should strike a foreign object or ice jam, the snowblower is
designed so that the lock pins may shear.
If the augers will not turn, check to see if the lock pins have
sheared (Fig. 24B). Replacement shear pin(s) and clip(s) are found
on the back of the control panel (Fig. 24C).
Figure 24A
A
b
Figure 24B
