LOCK
L
I
GHT
*3-Button Remote Controls
If provided with your garage
door opener, the large button
is factory programmed to
operate it. Additional buttons
on any S
®
3-Button
remote or mini-remote can be
programmed to operate other
S
®
garage door
openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first erase
all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or
keyless entry you wish to use.
1. Press and hold the button on the hand-held
remote
*
that you wish to operate your garage
door.
2. While holding the remote button, press and
hold the LIGHT button on the Multi-Function
Door Control.
3. Continue holding both buttons while you
press the push bar on the Multi-Function
Door Control (all three buttons are held).
4. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
“A”
Button
“B”
Button
To Add or Reprogram a Hand-held Remote Control
USING THE LIGHTED DOOR CONTROL
USING THE MULTI-FUNCTION DOOR CONTROL
"A"
Button
"B"
Button
LOCK
L GH
LOCK
L
I
GHT
PROGRAMMING
36
1. Remove the cover from the Lighted Door
Control.
2. Press and hold the button on the hand-held
remote
*
that you wish to operate your garage
door.
3. While holding the remote button, press and
hold the “A” button on the Lighted Door
Control.
4. Continue holding both buttons while you
press the “B” button on the Lighted Door
Control (all three buttons are held).
5. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional S
®
remote controls.
NOTICE:
If this S
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
