4
201101-01
Wall
Mounting Bracket
FINAL ASSEMBLY
1. Double check all wiring connections.
2. Slide the fixture assembly onto the mounting
screws as shown on outer carton packaging. Make
sure wires do not obstruct mounting screws (see
Figure 4).
3. Tighten decorative nuts removed in step 1 of In-
stallation section securely against fixture base.
4. Caulk around fixture base with silicone weather
sealant.
IMPORTANT:
Ensure that the drain hole
at the bottom of the unit is not blocked.
5. Install bulb. Do not exceed wattage rating on
fixture label.
6. If applicable, install fixture top using two
decorative screws (see Figure 5).
7. If applicable, remove nut below sensor and
install fixture tail assembly (see Figure 6). Use
the nut removed to secure the tail assembly.
Mounting Screw
Terminal Block Insulator
Decorative Nut
Terminal Block
From Fixture
From AC Source
WIRING
Connect the fixture wires to the terminal block
according to diagram. Make sure all screws on
terminal block are tightened securely and terminal
block insulator is folded over terminal block.
WARNING: Turn power off at circuit
breaker or fuse. Place tape over circuit
breaker switch and verify power is off at
the fixture.
WARNING: Risk of electric shock.
Terminal block insulator must cover
terminal block after wiring is complete.
Green/Yellow
Green/Yellow
Blue
Blue or Black
Brown
Red or Brown
Figure 3
Figure 4
IMPORTANT: Mounting bracket must be
earthed. Attach earth wire to bracket at the
earth screw. Tighten earth screw securely
against earth wire.