3
201101-01
INSTALLATION
This light fixture must be installed by a
licensed electrician or other person autho-
rized by legislation to work on fixed wiring
or other electrical installations.
IMPORTANT:
Do NOT use with dimmers or
timers.
For best performance, mount the fixture about
1.8 meters (6 feet) above the ground. This fixture
comes with a mounting bracket. It is pre-assembled
on the fixture for shipping.
1. Remove two decorative nuts.
2. Remove mounting bracket.
3. Tighten fixture mounting screws finger tight
onto mounting bracket.
4. Position mounting bracket against the wall and
mark the positions for the mounting screws
and the earth screw.
Note:
Make sure fixture
mounting screws are parallel to the ground before
tightening bracket to wall (see Figure 2).
5. Use a power drill to drill into the wall to provide
a suitable mounting for the screws.
Note:
Also
drill a 6 mm deep pilot hole for the earth screw.
• Bracket mounting screws are not included.
Use 4 mm dia. (8G) x 30 mm screws.
• Care should be taken to avoid drilling or
screwing into concealed electrical wiring.
• For solid brick walls, screws and masonry
plugs should be used.
6. Attach mounting bracket to wall with a minimum
of two screws. Use any slots that work best for
the type of installation.
Note:
Make sure fixture
mounting screws are parallel to the ground before
tightening bracket to wall (see Figure 2).
WARNING: Turn power off at circuit
breaker or fuse. Place tape over circuit
breaker switch and verify power is off at
the fixture.
Note:
We recommend having an assistant help hold
the lantern assembly during the wiring process.
Mounting
Bracket
Decorative Nut
Fixture
Mounting Screw
Bracket
Mounting
Screws (Not
Included)
Fixture
Mounting
Screws
Earth Screw
Mounting
Bracket
Figure 1
Figure 2