27
SETTING OPERATING MODES
The RPD10ER, RPD15ER, RPD25ER and RPD40ER drives have the
following operating modes (
factory setting is Mode 1
).
1.
Mode 1
End positions, Reversing completely on detecting an
obstacle in the OPEN position.
Settings Mode 1:
• Press the
OPEN
and
CLOSE button
on the handheld trans-
mitter simultaneously
• Then press the
Stop button
2 x
•
Now press the
OPEN
and
CLOSE button
simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 1 is now set (
End positions, reversing completely to the OPEN
position when an obstacle is detected
).
2.
Mode 2
End positions, reversing to OPEN position on detection of
obstacle for 2 seconds.
Settings Mode 2:
• Press the
OPEN
and
CLOSE button
simultaneously
• Then press the
Stop button 4 x
•
Now press the
OPEN
and
CLOSE button
simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 2 is now set (
End positions, reversing on detecting an obsta-
cle for 2 seconds in OPEN position
).
3. Mode 3
End positions, stop on detecting an obstacle.
Settings Mode 3:
• Press the
OPEN
and
CLOSE button
simultaneously
• Then press the
Stop button 3 x
•
Now press the
OPEN
and
CLOSE button
simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 3 is now set (
End positions, obstacle detection stop
).
4.
Mode 4
Only end positions (no obstacle detection).
Settings Mode 4:
• Press the
OPEN
and
CLOSE button
simultaneously
• Then press the
Stop button 6 x
•
Now press the
OPEN
and
CLOSE button
simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 4 is now set (
End positions only, no obstacle detection
).
2 x
}
1 x
}
1 x
4x
}
1 x
}
1 x
3x
}
1 x
}
1 x
6 x
}
1 x
}
1 x
en