25
After programming the end positions, these can only be changed by
means of the master handheld transmitter. (Master handheld transmitter
= handheld transmitter that was programmed first, see section "Master
handheld transmitter" for details.
8.
Changing end positions
If it is necessary to adjust the
OPEN
or
CLOSE
position, the end positions must be set according to
steps 1-7
.
9. Setting the middle position
Move the roller shutter to the desired po-
sition and stop it. Activate the
learn button
on the "Master Transmitter"
2 x (Fig. 22)
and press the
STOP button (Fig. 23)
. The motor confirms
this input by briefly turning once in one direction. The middle position
has been successfully learned.
10.
Operating the middle position
To use the function "middle position"
move the roller shutter to a position and press the
STOP button
on the
handheld transmitter for 3-4 seconds
(Fig. 24)
. The motor will automat-
ically drive to the set middle position. To exit the middle end position,
simply press the
OPEN
or
CLOSE button
on the remote contol.
Note:
The middle position can only be set after successfully programming the
OPEN and CLOSE position
.
Fig. 22
Fig. 23
Fig. 24
Fig. 25
0
Red Button
Follow these steps to delete the end/middle position:
•
Switch off the power supply.
•
Switch on the power supply again. The motor confirms this input by
briefly turning once in one direction.
• Press the
red button
on the motor
10 x (Fig. 25)
10 bleeps
• Then hold down the
red button
again for approx. 2 seconds. The
motor confirms this input by briefly turning once in one direction.
End positions cleared successfully.
DELETING END POSITION
╬
en