12
Attach the Emergency
Release Rope and
Handle
Install the Single
Button Control Station
3
4
1. Insert one end of the emergency
release rope through the handle.
Make sure that “NOTICE” is right side
up. Secure with an overhand knot at
least 1" (2.5 cm) from the end of the
rope to prevent slipping.
2. Insert the other end of the emergency
release rope through the hole in
the trolley release arm. Mount the
emergency release within reach, but
at least 6 feet (1.83 m) above floor,
avoiding contact with vehicles to
prevent accidental release and secure
with an overhand knot.
NOTE:
If it is necessary to cut the rope,
heat seal the cut end with a match or
lighter to prevent unraveling.
Installation
Door Operator
Emergency Release Cable
Overhand Knot
Overhand Knot
Emergency Release Handle
To prevent possible SERIOUS INJURY or DEATH from a falling door:
• If possible, use emergency release handle to disengage door ONLY when door
is CLOSED. Weak or broken springs or unbalanced door could result in an open
door falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless doorway is clear of persons and
obstructions.
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is NOT connected BEFORE installing door control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing door:
• Install door control within sight of commercial door, out of reach of children at
a minimum height of 5 feet (1.5 m) above floors, landings, steps or any other
adjacent walking surface, and away from ALL moving parts of door.
• NEVER permit children to operate or play with door control push buttons or
remote controls.
• Activate door ONLY when it can be seen clearly, is properly adjusted and there are
no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER permit anyone to
cross path of closing door.
132A2112-2
132LA2112-20-A
Shown at 100% (4.25" x 2.375")
ECN: 07-0326
14-May-2007
DO NOT EXCEED 10 DOOR OPERATIONS
PER HOUR.
FASTEN LABEL ADJACENT TO DOOR.
NE PAS FAIRE FONCTIONNER LA PORTE
PLUS DE 10 FOIS PAR HEURE.
FIXER L’ÉTIQUETTE PRÈS DE LA PORTE.
NO OPERE LA PUERTA MÁS DE 10
VECES POR HORA.
SUJETE LA ETIQUETA JUNTO A LA
PUERTA.
40-35246-10-A
Shown at 100%
ECN: 09-2104
4-May-2009
Red White
WHT
To insert or release wire, push
in tab with screwdriver tip
Single Button
Control Station
WHT/RED
Install the door control within sight of
the door, out of reach of children at a
minimum height of 5 ft. (1.5 m) above
floors, landings, steps or any other
adjacent walking surface, and away from
the moving parts of the door.
1. Remove the control station cover.
2. Fasten the control station to the
wall at least 5' (1.5 m) above floors,
landings, steps or any other adjacent
walking surface. The installation
surface must be smooth and flat.
3. Select appropriate knockout and run
the wires to the operator.
4. Connect wires to the control station
and replace the control station cover.
5. Fasten the warning placards to the
wall next to the single button control
station.
NOTE:
DO NOT connect the power and
operate the door operator at this time. The
door will travel to the full open position but
will not return to the close position until the
safety reversing sensors are connected and
properly aligned. See page 13.
