2
Install new receiver logic board
3
3.1
Connect the wire harnesses to
the new receiver logic board.
3.3
Reinsert the wires.
Door control wires:
• white wire into the white terminal.
• white/red wire into the red terminal.
Safety sensor wires:
• white wires into the white terminal.
• white/black wires into the
grey terminal.
NOTE:
A TEST OF THE SAFETY REVERSE SYSTEM IS NECESSARY FOR SAFE OPERATION.
To insert or remove the wires
from the terminal, push in the
tab with a screwdriver tip.
1
Programming
1.1
Press and release the Learn button on the garage door opener. The Learn indicator light will
glow steadily for 30 seconds.
1.2
Within 30 seconds, press and hold the
button on the remote control.
1.3
Release the button when the garage door
opener light blinks. It has learned the
code. If light bulbs are not installed, two
clicks will be heard.
Program a remote using the learn button
Learn
Indicator
Light
Yellow Learn
Button
3.4
Install the light lens by aligning with
the hinges and snapping into place.
Reconnect power.
NOTE:
When installing the light lens, ensure the antenna
wires are hanging straight down.
3.2
Insert the antenna wires through the holes in
the end panel. Snap the receiver logic board into
place on the end panel and fasten with screws.
NOTE:
Some models will
require the short antenna
wire to be placed in the
traps of the end panel.
Antenna wires
Antenna
wires
Red
White
White
Grey
