Challenge Spartan 185 SA, Руководство оператора

Страница: 10 / 22

5.0 Installation & Setup
10
Clear area in front of ramp. Using two or more persons, carefully roll machine off skid using lifting
handles as shown in Figure 4.
Figure 4
Remove lifting handles and roll machine into position. Lock casters to prevent machine from
inadvertently rolling.
5.3 Cleaning
After unpacking, wipe down all machine panels and surfaces with a clean cloth.
5.4 Power Hook-Up
SHOCK HAZARD! NEVER CUT THE GROUND TERMINAL from a three-
prong plug to fit a two-prong socket. Possible shock could cause personal injury or death. Hire a
qualified electrician to provide a power source that meets electrical requirements and all local
electrical codes.
It is the customer’s responsibility to provide a properly grounded receptacle that meets the power
requirements specified on the nameplate of this machine, as well as all local electrical codes. Have a
qualified electrician install one if your location is not so equipped. The socket-outlet shall be installed
near the machine’s location and be easily accessible.
Connect the power cord into a grounded, 3-prong receptacle only!
120 Volts 60 HZ. 16 Amps,
Service Size 20 Amps Receptacle NEMA 5-20R
Figure 5