Challenge MS-10B, Инструкция по эксплуатации

Страница: 17 / 29

6.0 Installation Guide
16
Swing the front cover back unit it rests on top of the machine. Loosen the drill head clamp located on
the back of the drill head. Place the head on the dovetail of the drill and slightly tighten the clamp
screw. Position the head by sliding it along the dovetail and then aligning the drill head indicator with
the scale and tightening the clamp screw. (Figure 7)
Figure 7
Insert the spline shaft through each head (you may have to rotate the spline to align the it with the drill
head gear) until it seats in the left hand spline bearing. The spline must go in far enough to enable
the spline lock ring to secure the spline shaft pin. Insert the spline pin into the lock ring and rotate to
lock. (See Figure 5,on page 15) Close and secure plastic cover.
6.5.3 Mounting the Side Guide
The side guide is mounted to the table with the two cap screws provided. It can be positioned as nec-
essary along the line of mounting holes in the table. After it is positioned, the guide plate can be ad-
justed by loosening the knurled lock nut and turning the micro-adjust knob. (Figure 8)
Figure 8
Head Clamp
Dovetail
Position Indicator
Scale
Side Guide Plate. Knurled Lock
Nut
Micro-Adjust
Knob
Mounting Screws