Challenge ME1030M, Инструкция по эксплуатации

Страница: 15 / 19

motor has been switched off. Never attempt to stop the blade.
Check regularly that the blade is correctly secured, in good condition and
well ground. If not, grind or replace the blade. If the moving blade strikes an
object, stop the mower and wait until the blade has come to a complete
standstill. Then check the condition of the blade and the blade holder. If they
are damaged, they must be replaced.
Place the mains lead in loops on the ground in front of the socket. Mow away
from the socket and cable and ensure that the mains lead is always on the
section of lawn that you have already mowed so that you do not run over the
mains lead with the mower. As soon as you see mown grass on the lawn
whilst you are mowing, the grass bag will need emptying.
Important!
Before you remove the grass bag switch off the motor and wait until the
cutting tool reaches a standstill.
To remove the grass bag, raise the discharge flap with one hand and remove
the grass bag using its handle with your other hand. To maintain safety, the
discharge flap will close when you remove the grass back to seal the rear
discharge opening. If any grass residues are caught in the opening, it is a
good idea to pull the mower backwards around 1 m to make it easier to start
the motor. Do not remove grass cuttings in the mower casing or on the cutter
by hand or with your feet. Instead use suitable tools such as a brush or
broom. To ensure that it can collect the grass correctly the grass bag and in
particular the net must be cleaned from the inside after use. Only attach the
grass bag after switching off the motor and the cutting tool has reached a
standstill. Raise the discharge flap with one hand and, holding the grass bag
by its handle in your other hand, attach it from the top.
8. Cleaning, maintenance and ordering of spare parts
Always pull out the mains power plug before starting any cleaning work.
8.1 Cleaning
● Keep all safety devices, air vents and the motor housing free of dirt and
dust as far as possible. Wipe the equipment with a clean cloth or blow it with