Challenge CHAMP 150, Руководство оператора

Страница: 16 / 26

6.0 Operation
16
position. Place the paper tight against the backgauge and either side guide using the jogging aid as
described previously. Now close the front shield then press and hold both clamp-only down buttons
(Figure 9).
A cut can now be completed with the paper already clamped, or the clamp can be released without
making a cut. To make a cut, press and hold both cut buttons as described in the previous section.
To release the clamp without cutting, press and release the clamp up button shown in Figure 9.
6.6 Operating Tips

For best results, it is a MUST to have a sharp blade in the cutter. A dull blade will pull or
draw the paper and cause uneven cutting.

Carefully lay out each sheet before cutting. Find the best cut pattern that gives the most
pieces out of the sheet. If the sheet will be folded, be sure the grain of the paper is running in
the same direction as the fold to avoid getting a rough edge on the fold.

Mark the gripper edge and the guide edge of printed paper and make sure the first cuts are
with these guide edges against the backgauge.

When cutting business cards or narrow strips of paper, place lifts of equal height on opposite
sides of the table to provide better clamping.