Challenge Xtreme CDI224MN, Оригинальное руководство пользователя

Страница: 10 / 16

HELPLINE NO 08448012949
10
OrIgINaL INstructIONs
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of
switch trigger depression.
WarNINg: Do not operate for long
periods at low speed because excess heat
will be produced internally.
3. sWItcH LOcK (see Fig. c)
The On/Off switch trigger can be locked in OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the forward and reverse
rotation selector in the center position by pushing
it on either side of the drill.
4. rEvErsIBLE (see Fig. D,E)
The forward and reverse rotation selector located
above the On/Off switch controls the direction of
rotation. For drilling and screw driving use forward
rotation marked “►” (lever is moved to the left)
(See Fig. D). Only use reverse rotation marked
“◄” (lever is moved to the right) to remove
screws or release a jammed drill bit (See Fig. E).
WarNINg: Never change the direction of
rotation when the chuck is rotating. Wait
until it has stopped.
5. tWO-sPEED gEar cONtrOL (see Fig. F)
The drill has a two-speed gear control designed
for drilling or driving at Low (mark is 1) or High
(mark is 2) speed. A slide control is located on
top of the drill to select either Low or High speed.
When using the drill in the low speed range, the
speed will decrease and the drill will have greater
power and torque. When using the drill in the high
speed range, the speed will increase and the drill
will have less power and torque.
gear I
Low speed range: for screwdriving or working
with large drilling diameter
gear II
High speed range: for working with small drilling
diameter
WarNINg: To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the two-speed
gear control.
6. cHucK aDJustMENt (see Fig. g)
To open the chuck jaws rotate the front section of
the chuck. Insert the drill bit between the chuck
jaws and rotate the front section in the opposite
direction. Ensure the drill bit is in the center of the
chuck jaws. Finally, firmly rotate the front chuck
section in the opposite directions. Your drill bit is
now clamped in the chuck.
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder