Challenge Xtreme CDI224MN, Оригинальное руководство пользователя

Страница: 11 / 16

HELPLINE NO 08448012949
11
OrIgINaL INstructIONs
7. FIttINg aND rEMOvINg scrEWDrIvEr
BIts (see Fig. H)
To use any short screwdriver bit supplied, insert
the bit into the bit holder and push the holder into
the chuck as far as possible. To remove the bit,
simply pull it out of the bit holder.
NOtE:
Always use a bit holder when fitting the
short bits.
8.tOrQuE aDJustMENt aND HaMMEr Or
DrILLINg cONtrOL (see Fig. I)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the
torque adjustment ring is set on a higher setting.
The torque is less when the torque adjustment
ring is set on a lower setting.
When drilling in masonry and concrete choose
the hammer position .
When drilling in wood, metal, plastic and
screwdriver choose the drill position .
Make the setting as follows:
1 - 4 for driving small screws
5 - 8 for driving screws into soft material
9 - 12 for driving screws into soft and hard material
13 - 16 for driving screws into hard wood
17 - 20 for driving larger screws
for heavy drilling
for drilling in masonry and concrete
9. DrILLINg
When drilling hard smooth surfaces, use a center
punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the
hole is started. Hold the tool firmly and place the
tip of the bit at the point to be drilled. Depress
the switch trigger to start the tool. Move the drill
bit into the work-piece, applying only enough
pressure to keep the bit drilling. Do not force or
apply side pressure to elongate a hole.
WarNINg: When drilling in metal, only
use Hss drill bits in good condition.
always use a magnetic bit holder when using
short screwdriver bits. When screw-driving,
apply a small quantity of liquid soap or similar
material to the screw threads to ease insertion.
10. usINg tHE sIgHt LIgHt(see Fig. K)
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder
Fig. A1
a
b
c
Fig. A2
Fig. B
Fig. C
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. J
Fig. K
d
bit holder