8-3
SECTION 8
ENTERTAINMENT
Class A
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna
Turn elevating crank clockwise in “UP”
direction until some resistance to turning is
noted. Antenna is now in operating position.
Turn amplifier power switch “ON” to receive TV
signal.
Rotating Antenna
Make sure antenna is in the “UP” position.
Pull down on directional handle until it
disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
“DOWN” direction until resistance is noted.
Antenna is now locked in travel position. Turn
amplifier power switch “OFF”.
TV SIGNAL AMPLIFIER
To operate the amplifier, turn on the power
switch.
TV jack plates are mounted in various
locations throughout the coach. Some of these
wall plates are not readily visible and may be in
one of the following locations.
•
In the front overhead TV cabinet, if equipped.
•
In the flip-down entertainment tray on the
outside of the coach.
•
Bedroom
Checking Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter. Signals may vary from strong to no
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
CAUTION
Always align directional handle to
“DOWN” position before lowering.