CHAFFOTEAUX 470 VERT, Инструкция по установке и обслуживанию

Страница: 65 / 76

EN
65
IMPORTANT : ONLY FOR WATER HEATER TRI
PROFESSIONAL TECH MUST ALWAYS BE SUP-
PLIED WITH 230V OR 400V AC.
IN CASE OF 400V TRIPHASE NETWORK
SUPPLY : PROfessional TECH CONNECTION
BETWEEN 2 PHASES 400V.
IN CASE OF 230V TRIPHASE OR 230V MO-
NOPHASE NETWORK SUPPLY : PROFESSIO-
NAL TECH CONNECTION BETWEEN PHASES
230V (Follow electrical wiring described on electri-
cal wiring tag)
O
PERATION
1. Introduction
1.1. User considerations
1. The installation of the water heater is the
responsibility of the purchaser.
2. This appliance is not intended for use by
persons (including children) with reduced physical,
sensory or mental capabilities, or lak of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
3. The end user is responsible for recycling the
appliance once it can no longer be used. For
further information, please consult the introduction
of this booklet 1.1. – Regulations relating to
transportation, storage and recycling.
2. Operating advice
2.1. Temperature adjustment
We recommend the thermostat is not set to its
maximum position, in order to avoid limescale
build-up and prevent burns. It is nevertheless
essential to
ÀQG a suitable compromise so as to
avoid bacterial proliferation while trying to prevent
the water heater from experiencing unnecessary
limescale build-up.
On the other hand, in order to prevent burns,
a suitable mixer should be used so that the
temperature does not exceed 50°C at any of the
drawing points. This is a compulsory regulation in
France.
When using a mixer at a drawing point,
we recommend that the temperature is
set to approximately 60ºC.
2.2. Maintenance
Empty the appliance annually ( twice a year
if the water has been treated with a softening
agent
) in order to:
1. check the condition of the magnesium anode;
2. remove all deposits inside the boiler.
Contact your installer.
Picture 15- PTEC
2.3. Indicator lights
2.3.1 Products PROfessional TECH steatite
range
The boiler protection anode is controlled by an electronic
device powered at the network current or using a battery
designed for systems operating in day/night mode, in or-
der to keep the boiler protected during the day.
The PROfessional TECH system cannot be left without a
power supply for over 48 hours
PROTECTION ON
HEATING ON