CAMERA INSTALLATION
(1) Drill the mounting holes by using the alignment paper.
(2) Insert 4 screw anchors into the wall.
(3) Insert 2 screws into the screw anchors, reserved space 8 to 10 mm. Then Hang the camera on 2 screws.
(4) Fasten 4 screws by using hex key
OTHERS
Specifications
Hotline
www.chacon.be
Symbols
Direct current (DC)
Don’t throw batteries or out of order products with the household waste (garbage). The
dangerous substances that they are likely to include may harm health or the environment.
Make your retailer take back these products or use the selective collect of garbage proposed
by your city.
FCC Compliance Statement: This device complies with Part
15 of the FCC rules. Operation is subjected to the following two conditions: (1)this device may not
cause harmful interference, and (2) this device must accept any interferencereceived, including
interference that may cause undesired operation
Hereby, Chacon, declares that the radio equipment type « 34564 » is in compliance with the Directive 2014/53/UE.
The full text of the EU declaration of conformity is available at the following Internet address:
http://chacon.be/conformity
Chacon S.A.
Avenue Mercator 2 • 1300 Wavre
Belgium
General
Transmission frequency
WiFi 802.11 b/g/n
Max power consumption (EIRP)
<100mW
Caméra
Resolution
1080P
View angle
90°
Enclosure protection
IP66
Night vision
12m
Supply voltage
Adaptor (5VDC)
Note: Before mounting the camera, install the memeory card if you prefer recording to local storage