YELLOW
WIRES
RED WIRES
FROM
OPERATOR
PRESENCE
SWITCH
FIGURE 9
Honda Engine Shown
13. Route the throttle cable through the air cleaner
cover as shown. See Figure 10.
1
5393
FIGURE 10
1. Throttle Cover on Briggs Engines
14. For Honda engines loosen and remove wing nut
securing air cleaner cover. Remove cover and ele-
ment to allow access to throttle. See Figure 11.
1
FIGURE 11
1. Wing nut on Honda Engines
15. For Briggs engine route throttle cable to engine and
secure with clamp and hardware as shown in Figure
12 (for Honda engines route cable to the inside of
bracket).
1
2
5390
FIGURE 12
Briggs Engine Shown
1. Cable Clamp
2. Throttle Cable
3
4
FIGURE 13
Briggs Engine Shown
1. Z-bend End
2. Engine throttle Lever
3. Throttle Cable
4. Cable Clamp
7
1
2
16. For the Briggs engine. Grab the end of the throttle
cable and pull the cable upwards, while turning
the front end down and insert the Z-bend into the
engine throttle lever hole. See Figure 13
NOTE: To make this step easier, the air cleaner
cover can be removed by taking out the
screw.
Move the engine throttle lever full forward. Move the
throttle control lever on the handlebars full forward.
Remove the cable clamp. Position the throttle cable
under the cable clamp screw. Re-install the clamp
screw while pushing the cable body forward. Move
the throttle control back and forth and check for full
high idle. Re-adjust if neccessary. Replace the air
cleaner cover and screw if it was removed.
Содержание RYAN JR SODCUTTER 544844E
Страница 28: ...SPANISH 26...
Страница 67: ...SWEDISH 65...