![Cessna TU206G STATIONAIR Скачать руководство пользователя страница 80](http://html1.mh-extra.com/html/cessna/tu206g-stationair/tu206g-stationair_pilot-operating-handbook_2584552080.webp)
SOLOY TURBINE PAC
SECTION 4
POHS CESSNA U/TU 206G
NORMAL PROCEDURES
4-14
F.A.A. Approved
October 4, 2005
To prevent loss of fuel in flight and to ensure equal flow, make sure the
fuel tank filler caps are tightly sealed. The fuel tank vents on the lower
surface of the tanks should also be inspected for obstructions.
BEFORE STARTING THE ENGINE
After the preflight interior and exterior checks have been completed and
the airplane is determined ready for flight, the cabin doors and window
should be secured. Passengers should be briefed on the use of seat belts
and shoulder harnesses, the emergency exits, supplemental oxygen (if
available), ventilation controls, seat adjustments, etc.. After all seats are
adjusted and secured in position and seat belts and shoulder harnesses
are properly fastened, the pilot may prepare to start the engine.
The parking brake should be set ON by pulling out on the brake handle
and turning it 90
down. Check that the fuel selector is ON (BOTH if the
fuel low warning system installed) and the fuel cutoff control is in the
CUTOFF position (OUT). Place the propeller control fully FORWARD and
the power control at GROUND IDLE.
Prior to starting the engine, check that all electrical switches and avionics
are OFF, and that all circuit breakers are IN.
CAUTION
PRIOR TO TURNING THE BATTERY SWITCH ON OR
APPLYING AN EXTERNAL POWER SOURCE, THE
AVIONICS POWER SWITCH, LABELED AVIONICS
POWER, SHOULD BE TURNED OFF TO PREVENT ANY
HARMFUL TRANSIENT VOLTAGE FROM DAMAGING
THE AVIONICS EQUIPMENT.
The generator switch should be in the APU (OFF) position to reduce the
load on the engine’s N
1
section for starting. For cooler and faster start and
to extend the battery life, it is recommended that an APU be used when
convenient, and especially when the ambient air temperature is less than
-18
C (0
F). With the battery switch ON, the AUTO FEATHER light should
illuminate. This indicates that the auto feather pressure sensor is
operating. In addition, the OIL PRESS LOW, and the GEN OFF BUS
lights will be illuminated. The remaining lights should be checked by the
PRESS-TO-TEST feature.
NOTE
At the lower voltages prior to engine start, the
PRESS-TO-TEST feature of the annunciator
lights will only operate with the light intensity
set to bright.
UNCONTROLLED
COPY