CERTIFIED 060-3732-6, Инструкция по эксплуатации

Страница: 33 / 52

33
MAINTENANCE
4. Carefully remove the M10 hex nut (3)
which secures the hex shaft (4) to the
snowblower frame and lightly tap the
shaft’s end to dislodge the ball bearing from
the right side of the frame (Fig. 28).
Figure 28
5. Carefully position the hex shaft downward
and to the left before carefully sliding the
friction disc assembly (5) off the shaft
(Fig. 29).
Figure 29
6. Unscrew the six M6 × 16 bolts (6) of the
friction disc assembly to discard the worn
friction wheel rubber ring (7) and replace
with a new one (Fig. 30).
Figure 30
7. Follow the previous steps in reverse order to
reassemble the parts.
8. Perform a drive test to confirm everything
is in working order.
LUBRICATION
Lubricate the linkage every 10 hours of use and
before long-term storage. Use 0W-30 oil.
No parts inside the gearbox are to be lubricated.
All bearings and bushings are permanently
lubricated and require no maintenance.
Lubricating these parts will only result in the
grease getting on to the friction wheel and disc
drive plate, which could damage the rubber clad
friction wheel.
3
7
5
4
6