Cerner MDC-2, Руководство оператора

Страница: 7 / 19

MDC-2
Operator’s Manual
3
saFetY
Electrical
The MDC-2 is intended to be operated from a mains power source of nominally 00 to 230V~,
47 to 63 Hz and Maximum AC Power consumption: 145 VA.
Warning: The Cerner Connectivity Engine (MDC-2) is only approved for use with a Cerner
Medical Device Adapter (MDA-).
WARNING: To prevent electrical hazards to all personnel, this device must be properly ground -
ed. Connect the device only to a three-wire, grounded, hospital grade receptacle. The three-conduc-
tor plug must be inserted into a properly wired three-wire receptacle; if a three-wire receptacle is not
available, a qualified electrician must install one in accordance with the governing electric code.
WARNINg: Do not under any circumstances remove grounding conductor from the power plug.
WARNINg: The hospital-grade power cable supplied with this equipment provides for this
protection. Do not attempt to defeat this protection by modifying the cable or by using ungrounded
adapters or extension cables. The power cord and plug must be intact and undamaged. It is the
user’s responsibility to use the proper power cord for the country where the MDC-2 is being used.
WARNINg: Do not connect to an electrical outlet controlled by a wall switch or dimmer.
WARNINg: If there is any doubt about the integrity of the protective ground conductor
arrangement, do not operate the MDC-2 until the AC power source protective conductor is fully
functional.
WARNINg: Do not place the MDC-2 in any position that may cause it to fall on the patient. Do
not lift the MDC-2 by the power supply cord or other cables.
WARNING: Electric shock hazard! Do not remove covers or panels. Refer service to qualified
service personnel.
WARNINg: To avoid electrical shock, disconnect the MDC-2 from its power source before
changing fuses. Replace fuses only with same type and rating T1.6A 250V (Metric 5x20mm).
WARNINg: Do not clean MDC-2 while it is on and/or plugged into a power source.