CEP AG
Revision 1.2
_________________________________________________________________________________
__________________________________________________________________________________________
Page 2 of 28
Important information
This technical description contains important information for start up and use of the GT864-QUAD/PY
Terminal. Read it carefully before you start working with the GT864-QUAD/PY Terminal.
The warranty will be void should damage occur due to non-compliance with these instructions for use.
We cannot accept any responsibility for consequential loss.
We cannot be held responsible for material loss or personal injury that is due to incompetent use or
non-compliance with the safety instructions. The warranty will be void in such circumstances.
The GT864-QUAD/PY Terminal contains highly integrated components which can be damaged by
electrostatic discharge if the user would open the housing.
Therefore only touch the GT864-QUAD/PY Terminal on the housing or
connectors and avoid touching the components on the board.
Safety Instructions
When using products which are exposed to electric voltage the valid
regulations have to be observed.
Before opening of a device always pull the mains adapter or make sure that the device is
disconnected from the power supply.
You should only use tools on components, modules or devices if they are disconnected from the
power supply and the electric charge, which may still be stored in some components, inside the device
has been discharged.
All cables and wires which are energized and connected to the device, the module or components
have to be checked regularly for any damage of the isolation shield or fractures of the cables. If the
supply cables are visibly damaged the device has to be taken out of operation immediately until the
faulty cable has been exchanged.
When using components or modules it is necessary to strictly observe the specification given in the
corresponding description of these components. If a description for a private end-customer not clearly
states which electric data is valid for a component or a module, how to wire the device, which external
components or additional devices can be connected or which parameters these components are
allowed to have, a specialist must be contacted.
Before putting a device into operation, it has to be clarified, whether this device or module is meant for
the field of application. In case of doubt ask specialists or the manufacturer of the device.
Please note that we are not responsible for any errors in usage or connection. Therefore we cannot
accept any responsibility for consequential loss.
Devices which operate with >35 Volt have to be connected by a specialist. Before putting the device
into operation it should be checked that there is no current leakage on the housing.
In case those measurements with the opened housing are necessary, an isolating-transformer has to
be integrated for safety reasons. Alternatively the voltage can be supplied by an appropriate power
supply which complies with the safety regulations. All wiring work has to be done in a voltage free
state only.
