CenturyLink c1100t, Руководство по установке

Страница: 7 / 7

TECHNICOLOR WORLDWIDE HEADQUARTERS
1, rue Jeanne d’Arc
92443 Issy-les-Moulineaux
France
www.technicolor.com
*DSL37273170*
DSL37273170
Copyright 2014 Technicolor. All rights reserved.
All tradenames referenced are service marks, trademarks,
or registered trademarks of their respective companies.
Specifications subject to change without notice.
DMS3-SAF-25-9 v1.0. Printed in Vietnam.
Federal Communications Commission (FCC) Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Responsible Party: Technicolor, 101W. 103rd St., Indianapolis, IN 46290 USA, 317-587-5466.
This equipment complies with Part 68 of the FCC Rules. The customer information required for
Telephone Terminal Equipment ("TTE") approved for connection to the Public Switched Telephone
Network ("PSTN"), pursuant to 47 CFR §68.218(b)(1) can be found at www.technicolor.com.
RF-exposure statement
When the product is equipped with a wireless interface, then it becomes a mobile or fixed mounted
modular transmitter and must have a separation distance of at least 20 cm (8 inches) between the
antenna and the body of the user or nearby persons. In practice, this means that the user or nearby
persons must have a distance of at least 20 cm (8 inches) from the modem and must not lean on the
modem in case it is wall-mounted.
With a separation distance of 20 cm (8 inches) or more, the M(aximum) P(ermissible) E(xposure) limits
are well above the potential this module is capable to produce.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless transceiver and may
only use channels 1 to 11 (2412 to 2462 MHz) on U.S.A. territory.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause
undesired operation.