Century SmartMove, Инструкция по эксплуатации

Страница: 8 / 30

When using car seat rear-facing , car seat MUST
be able to rotate freely from a reclined to an
upright position on impact.
• Test by moving car seat through all seating
angles.
Adjust car seat to reclined or semi-reclined
position and place rear-facing on vehicle seat.
Thread vehicle seat belt through openings over
recline lever on front of car seat and buckle
belt
(fig. a) .
Press down firmly in center of car seat to
compress vehicle seat cushion while tightening
vehicle seat belt
(fig. b) .
Because of car seat design, you may experience
some movement of the pointer in positions
1 & 2 during vehicle seat belt tightening.
This is normal. Make sure you start installing
car seat with pointer in the locked position
1 or 2 and adjust the vehicle belts keeping the
pointer within the colored zone
(fig. c) .
REAR-FACING INSTALLATION
1
2
6
Pull front to back and left to right to check for
secure installation
(fig. d) . Vehicle lap belt
MUST stay tight.
If not secure, see “Vehicle Seat Belts” section.
Check level indicator on car seat.
Ball MUST be entirely in green zone (fig. e) . If
necessary, place rolled towels under car seat, at
vehicle seat crease, until entire ball is in green
zone. Then re-check level indicator.
NOTE: Vehicle must be on level ground and
child in car seat when checking level indicator.
4
5
To prevent serious injury or death:
Do not allow anything in vehicle
interior or in base of car seat to obstruct
rotation in a crash.
WARNING
3