Radikal G30 v.2
Page 23
CLUTCHBELL ASSEMBLY
CNM4x4SS
CNBB1015
CNBB513
CNBB1524
CNBB511
BAG 2
The Radikal uses the starting shaft and
hex coupler to align the clutch to the
clutchbell. Clean both the starting shaft
and the inside race of the one-way bear-
ing inside the clutchbell and the inside
race of the top starting shaft bearing.
Apply a small amount of Red threadlock
positioned just above where the top of
the clutchbell will be recessed within the
bearing (#8). From the bottom, slide the
starting shaft up through the bearing
blocks. Apply a small amount of medium
threadlock to the top of the starting shaft
and slide the hex coupler in place align-
ing the flat spot with one of the holes. Ap-
ply medium threadlock to the M4x4 set
screw and tighten in place.
Clean the top of the pinion gear and the inside surfaces of both the upper
and lower bearings inside the clutch shaft bearing block using alcohol.
Apply a small amount of Red threadlock to the top edge of the clutch gear
where it will contact the bearing (#6). Press the bearing block in place,
firmly seating the bearing against the top of the pinion gear.
The hex starting system is a regular replacement part and will wear
due to normal use. The pull start option is a better alternative to
starting the helicopter. You can use a pull start for the first start of
the day. Afterwards, using a heavy duty electric starter is possible.
Set Screw(
无头内六角螺丝
)M4x4
2
CNM4x4SS
Hexagon Head Start(
六角启动头
)
1
HW6002
1
Bearing(
滚珠轴承
)5x13x4
CNBB513
2
Bearing Block(
轴承座
)
4
Long Hex Spacers(
六角铝柱
)L=52MM
Alloy Drive Gear 14T(
合金传动齿轮
)
1
Bearing(
滚珠轴承
)15x24x5
CNBB1524
1
Clutch Bell Assembly 67mm (
离合器罩
)
1
1
Bearing(
滚珠轴承
)5x11x4
CNBB511
Starting Shaft(
启动轴
)
1
HW6013G3
HW6006G3
No.
Description
Qty
1
2
3
4
6
7
5
8
9
10
11
1
Bearing(
滚珠轴承
)10x15x4
CNBB1015
Part #
HW6007G
HW6007GS
HW6043A
Clutch Liner(
刹车皮
)
HW6014B
12
1
1
2
3
4
5
6
7
8
9
10
11
12
