Radikal G30 v.2
Page 19
MAIN GEAR ASSEMBLY
BAG 3
1
2
3
4
5
7
6
CNM3x6FHCS
CNM3x8FHCS
Drop some medium threadlock into the
four holes on the driven tail hub. Then
use the M3x6 flush head cap screws
and install through the tail drive gear
tightening onto the driven tail hub.
Make sure to use threadlock sparingly
as to not get excess threadlock onto the
plastic gear. Apply medium threadlock
to the six holes on the dual bearing au-
to-rotation hub and install the gear onto
the hub. Then using the M3x8 flush
head cap screws torque down onto the
main gear. Make sure the flush head
cap screws are installed onto the con-
cave beveled side of the screw holes on
the main gear.
Be sure to clean the inside and outside of the main shaft
sleeve with alcohol prior to installation.
For the roller bearings, we recom-
mend a very light oil. The oil MUST-
NOT attack/break down plastic as
this could damage the cage in the
one-way bearing. Prior to applying oil,
make sure to clean the roller bear-
ings with a cotton swab making sure
there is no debris in the bearings.
If in the future your one-way bearing or
sleeve is worn or damaged, it is highly
recommended to replace the sleeve and
one-way bearing hub at the same time.
Driven Tail Hub(
传动主齿轮座
)
1
1
CNE510A
1
Main Gear(
传动主齿轮
)
Main Shaft Auto Sleeve (
主齿轮铁套
)
1
90T Main Gear(
斜齿轮
)
Auto Hub w/Dual One-way Bearing(
单向轴承座
)
1
Flush Head Cap Screws(
斜头内六角螺丝
)M3x6
CNM3x6FHCS
4
Flush Head Cap Screws(
斜头内六角螺丝
)M3x8
CNM3x8FHCS
6
HW6057C3
HW6057D3
No.
Description
Qty
1
2
3
4
6
5
7
Part #
HI6057C
HW6057A
